Woodworking engraving machine is used in the woodworking industry, decoration industry and other aspects of engraving equipment, which is mainly carved on wood, in order to make the wood can be more beautiful after carving. The engraving machine can also be processed on crystal, aluminum, copper, etc. Although the engraving machine is controlled by a computer, the engraving machine executes computer instructions.
With the engraving machine, as time goes by, the machine will use a long time to turn on the sound of the machine when it is turned on. It has a sharp metal friction sound, and the vent hole wood chips pile up in piles, which is to be maintained. If the engraving machine does not emit some sharp friction sounds, then the machine must be cleaned of dust, which may be caused by too much dust in the machine. Use needle-nosed pliers, universal needle car oil, small brush tool, the operation process is to first unplug the power cord, remove the plastic sheath, turn the screwdriver counterclockwise, unscrew the screw, remove the screw, use the needle-nosed pliers Remove the carbon brush and carefully mark the installation position of the carbon brush, so that the recovery is smoother. Use a brush to clean the dust. If there is an air spray gun, you can spray it with a spray gun.
Open the machine casing and use your fingers to rotate the motor shaft for metal friction. To make sure there is no dust inside, use the universal needle oil, drop the oil on the ring in the gap, and rotate the finger to ensure that the oil is eaten. According to the operation steps, cleaning the dust, you have to do it yourself, you can go to the woodworking machine manufacturer for cleaning and maintenance.
